Across the whole of the investigation I have encountered few difficulties than I had earlier predicted. Mechanically on that point were a issuing of problems that occurred that had previously been unseen. These included the weight of the bridge being so more(prenominal) than that the motor was non powerful enough to lift it and the problems of avoiding it destroying itself by not lemniscus at its maximum and minimum heights. at that place were also close to problems with the limit switches not working. Electronically, there were fewer problems exclusively they were, for the most part, harder to overcome. The first problem was get reacquainted with the boards. This was relatively easy after 15 minutes or so of trial and error. Other problems faced included the complexness of some designed systems. For the most part these were in like manner honest and basic for the control of the bridge itself. All of these were overcome without too practically difficulty and wit h a little thought and ingenuity. My system was slightly controlled and built.

There were few problems, however the ones that were incurred usually had a mountainous negative impact, such as the motor not stopping causing the bridge to collapse. The electronic systems that were designed originally were far too simple for the control of the bridge but these became more advanced as the project continued and I became old(prenominal) with the boards again. If you want to get a full essay, order it on our website:
OrderEssay.netIf you want to get a full information about our service, visit our page:
write my essay
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.